/*
  Example for different sending methods
  
  https://github.com/sui77/rc-switch/
  https://github.com/LSatan/SmartRC-CC1101-Driver-Lib
  ----------------------------------------------------------
  Mod by Little Satan. Have Fun!
  ----------------------------------------------------------
*/
#include <ELECHOUSE_CC1101_SRC_DRV.h>
#include <RCSwitch.h>

int pin; // int for Transmit pin.

RCSwitch mySwitch = RCSwitch();

void setup() {
  Serial.begin(9600);

#ifdef ESP32
pin = 2;  // for esp32! Transmit on GPIO pin 2.
#elif ESP8266
pin = 5;  // for esp8266! Transmit on pin 5 = D1
#else
pin = 6;  // for Arduino! Transmit on pin 6.
#endif

  if (ELECHOUSE_cc1101.getCC1101()){       // Check the CC1101 Spi connection.
  Serial.println("Connection OK");
  }else{
  Serial.println("Connection Error");
  }

//CC1101 Settings:                (Settings with "//" are optional!)
  ELECHOUSE_cc1101.Init();            // must be set to initialize the cc1101!
//ELECHOUSE_cc1101.setRxBW(812.50);  // Set the Receive Bandwidth in kHz. Value from 58.03 to 812.50. Default is 812.50 kHz.
//ELECHOUSE_cc1101.setPA(10);       // set TxPower. The following settings are possible depending on the frequency band.  (-30  -20  -15  -10  -6    0    5    7    10   11   12)   Default is max!
  ELECHOUSE_cc1101.setMHZ(433.92); // Here you can set your basic frequency. The lib calculates the frequency automatically (default = 433.92).The cc1101 can: 300-348 MHZ, 387-464MHZ and 779-928MHZ. Read More info from datasheet.
 
  // Transmitter on 
  mySwitch.enableTransmit(pin);

  // cc1101 set Transmit on
  ELECHOUSE_cc1101.SetTx();
  
  // Optional set protocol (default is 1, will work for most outlets)
  // mySwitch.setProtocol(2);

  // Optional set pulse length.
  // mySwitch.setPulseLength(320);
  
  // Optional set number of transmission repetitions.
  // mySwitch.setRepeatTransmit(15);
  
}

void loop() {

  /* See Example: TypeA_WithDIPSwitches */
  mySwitch.switchOn("11111", "00010");
  delay(1000);
  mySwitch.switchOff("11111", "00010");
  delay(1000);

  /* Same switch as above, but using decimal code */
  mySwitch.send(5393, 24);
  delay(1000);  
  mySwitch.send(5396, 24);
  delay(1000);  

  /* Same switch as above, but using binary code */
  mySwitch.send("000000000001010100010001");
  delay(1000);  
  mySwitch.send("000000000001010100010100");
  delay(1000);

  /* Same switch as above, but tri-state code */ 
  mySwitch.sendTriState("00000FFF0F0F");
  delay(1000);  
  mySwitch.sendTriState("00000FFF0FF0");
  delay(1000);

  delay(20000);
}